Falcon Transmission Crank Coupler - Late Chevy - 18 Spline w/ 1 Piece Rear Main Seal RS00100314 Helmet shields for FIA 8860-2018

Helmet shields for FIA 8860-2018 ST5 ABP helmets only

Dual layer design - Outer layer is hi-temp Titanium Inner layer is 89 percent silica to handle extreme heat Reduce heat soak into oil Easy installation with stainless steel Locking Ties Helps prevent Corvette from going into limp mode from engine oil becoming too hot Size is 14 in

Reversable

and does not leave a sticky residue after removal

1/4 in Diameter Probe

Falcon Transmission Crank Coupler - Late Chevy - 18 Spline w/ 1 Piece Rear Main Seal RS00100314 Helmet shields for FIA 8860-2018Crankshaft couplers for use with Falcon Transmission Late Model Transmissions. The Falcon Late Model Transmission has two forward speeds, neutral, and reverse, with an integral hydraulically applied clutch operating low and reverse gears. High gear is a direct drive 1 to 1 ratio with minimal rotating mass. With its aluminum case and extension housing, the Transmission weighs just 45 pounds. Its comparable dimensionally to a Muncie, T 10, and other